Firmware updates are one of the most essential updates for Linksys Smart Wifi routers. They are the ones which fix the different bugs and makes sure that the device is updated Hence, as a user, you must always keep your device firmware as updated as you can. Here, you can do it either by typing 192.168.1.1 Linksys log in on your Browser.
Further, a firmware downloaded from the Linksys Site does contain some device feature enhancements which were not present in the previous versions.
Ways in which you can keep your Linksys Smart Wifi Routers Updated
- Utilizing the Check for Updates Button
- Enable the Automatic Updates
Also, you can even do the manual update and then upload it to your router.
Utilizing the Check for Updates Button | 192.168.1.1 Linksys log in
Log in to your account on 192.168.1.1 Linksys log in or else, you can also visit the Linksys Cloud Account. After that, open the interface and click on Connectivity.
In case, you do not have a Linksys Cloud Account, you can access your router settings without even logging in to Linksys cloud account.
After you have logged in 192.168.1.1 Linksys log in, go to the Firmware section under the Basic Tab and check for updates. If there is an update, click on that.
Once, the router detects any firmware update, you can download and install that firmware on your device. Here, you will see a “Click Here” link, tap on that.
In case, you don’t find any updates, it means that your router is at its latest firmware version.
On the Update Firmware Version, Click Yes. After this, your router will begin the process of updating the firmware.
During the Updating Process, Don’t power off the Button or close the Internet Window for avoiding firmware update interruption.
Now, after the update process, router reboot screen will come up. Click on “OK” to continue.
The Router reboot process will take a couple of minutes to fully load up
Once the Firmware gets upgraded, click on “OK” and that’s all.
Enable Automatic Update
Log in to the Linksys Cloud account. Once it gets loaded click on Connectivity.
In case you don’t have a Linksys account, you can open your web browser and enter 192.168.1.1 Linksys log in the address bar. And, afterward, press Enter.
Now, right in the Firmware Update Section, check the Automatic Enable Box. Once it is done, click on Apply for saving the changes.
On the Linksys Smart Router, the automatic feature is disabled since factory settings on your device.
However, in an online situation, the router will detect the available updates to apply on your device.
On the “Update Firmware” pop up box, tap on Yes
Here, your router will start the process of updating the firmware.
Now, after the installation, the Router Reboot screen will come up. Click on “OK” to continue
Once the Firmware installation is complete, click OK and that is it.
All in all, after entering 192.168.1.1 Linksys log in, you can complete the firmware update process by following the above steps. And in a case, you get stuck up, again go through the above steps and you will succeed sooner or later.